Extron CCB 30 Bruksanvisning

Les nedenfor 📖 manual på norsk for Extron CCB 30 (1 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 4 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/1
68-2820-01 Rev. A
06 15
CCB 30 Installation Guide
The CCB 30 Contact Closure Remote for Cable Cubby Series/2 contains three contact closure
buttons to control input selection on Extron switchers and products with contact closure control
ports. Assemble the CCB 30 module and wire it to the control product as shown in this guide.
To wire the captive screw connectors:
1. Strip away 3 inches of the outer jacket
from the end of the cable, and 3/16 inch
(5 mm) of the inner jacket from the end of
each wire.
2. Secure the wires to the captive
screw connector as shown
at right. Follow the wiring
diagram on the left.
© 2015 Extron Electronics All rights reserved. www.extron.com
NOTE: See the table on the back to determine the
appropriate current-limiting resistor, if needed.
Step 1:
Assemble the CCB 30
module.
Use the module screws (2)
to secure the CCB 30 on the
connectivity bracket.
Step 2:
Wire the CCB 30 module to a switcher or control product.
Step 3:
Install the CCB 30 module in a Cable Cubby 700.
2
1
Insert the CCB 30
module into the
Cable Cubby.
Secure the module
using the provided
mounting screws (4)
and washers (4) on
the front and back
of the enclosure.
C
G
T
+V
C NO NC
Contact Closure
Input with Tally Output
RESISTOR
Contact (C)
Ground (G)
Tally output (T)
Tally voltage (+V)
PP
Wiring Diagram:
Momentary switch (single pole)
on captive screw terminal
Blue
1A @
24 VDC /
125 CVA
N/A 4.52 k 13 k
PP

Produkspesifikasjoner

Merke: Extron
Kategori: Ikke kategorisert
Modell: CCB 30

Trenger du hjelp?

Hvis du trenger hjelp med Extron CCB 30 still et spørsmål nedenfor, og andre brukere vil svare deg




Ikke kategorisert Extron Manualer

Ikke kategorisert Manualer

Nyeste Ikke kategorisert Manualer