Hudson Valley KBS1752803-AGB/SWH Bruksanvisning
Hudson Valley
Lettelse
KBS1752803-AGB/SWH
Les nedenfor 📖 manual på norsk for Hudson Valley KBS1752803-AGB/SWH (2 sider) i kategorien Lettelse. Denne guiden var nyttig for 2 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere
Side 1/2
SPLIT
KBS1752803
INSTALLATION INSTRUCTIONS
WARNING/CAUTION
DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE. READ ALL INSTRUCTIONS
COMPLETELY BEFORE STARTING INSTALLATION.
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL
APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES. THE INSTALLATION AND
MAINTENANCE OF THIS UNIT SHOULD BE COMPLETED BY A LICENSED ELECTRICIAN OR CERTIFIED
FACTORY TRAINED TECHNICIAN.
CALIFORNIA PROP 65: THIS LIGHTING FIXTURE CONTAINS CHEMICALS KNOWN TO THE STATE OF
CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS, AND/OR OTHER REPRODUCTIVE HARM. WASH HANDS
AFTER USE.
REMOVE THE FIXTURE, PARTS AND PARTS BAG(S) FROM THE CARTON. BEFORE DISCARDING THE
CARTON, DOUBLE CHECK TO MAKE CERTAIN THAT ALL PARTS ARE FOUND. INSPECT THE FIXTURE PRIOR
TO INSTALLATION FOR ANY DAMAGE TO THE FIXTURE.
DIMMING: THE FIXTURE CAN BE CONTROLLED BY A WALL DIMMING DEVICE. ONLY USE
TRIAC/ELECTRONIC DIMMER. MAKE SURE THE CARTON IS MARKED FOR USE WITH LED COMPACT
FLUORESCENT-INCANDESCENT LIGHT SOURCE ONLY. THESE CAN BE PROVIDED BY YOUR LOCAL
ELECTRICAL DISTRIBUTOR, HOME CENTER, OR HARDWARE STORE.
PLEASE CLEAN WITH A SOFT, DRY CLOTH ONLY! DO NOT USE CLEANSERS
www.hvlgroup.com
1
5
6
7
2
3
4
89
10
FIXTURE INSTALLATION
1. Attach the MOUNTING PLATE (1) unto the junction box using the MOUNTING SCREWS (2). This fixture is
designed to be mounted on standard round or octagon junction box. The junction box must be securely mounted
to the structure of the building.
2. Attach the Ground wire (Green) to the ground inside the outlet box (Generally green or bar copper wire) or the
GROUND SCREW (3) on the MOUNTING PLATE (1). NEVER CONNECT GROUND WIRE TO "HOT" WIRE!
FAILURE TO FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH!
3. Connect the white fixture lead to the neutral (Generally white) wire in the outlet box. Fasten the wires together
with an approved fastener (WIRE NUT) (4). Starting 1" below the fastener, tightly wrap the connection with
electrical tape so that the connections seals the end of the fastener. MAKE SURE THERE ARE NO EXPOSED
WIRE OF STRANDS THAT COULD CAUSE A DANGEROUS SHORT CIRCUIT!
4. Connect the black fixture leads to the hot (Generally black) wire in the junction box. Fasten the joined wires
same as previous step. NEVER REVERSE HOT AND NEUTRAL WIRES. FAILURE TO FOLLOW THIS
COULD RESULT IN SERIOUS INJURY OR DEATH!
5. Attach the FIXTURE ASSEMBLY (6) to the MOUNTING PLATE (1) and secure with the BOLT NUT (5).
6. Adjust the ARMS (8) and SWIVEL (9) to the desired Angle.
7.
8.
Screw the BULB (7) up into the SOCKET of the fixture.THIS FIXTURE IS RATED FOR 60 WATT TYPE G25
LAMP. DO NOT EXCEED THE RECOMMENDED WATTAGE!
Restore power to the outlet at the breaker or fuse box.
.
ITEM DESCRIPTION PART NUMBER
1MOUNTING PLATE HDW-KBS1752803
2MOUNTING SCREW HDW-KBS1752803
3GROUND SCREW HDW-KBS1752803
4WIRE NUT HDW-KBS1752803
5BOLT NUT HDW-KBS1752803
6FIXTURE ASSEMBLY FAS-KBS1752803
7BULB NOT INLCUDED
8ARMS FAS-KBS1752803
9SWIVEL FAS-KBS1752803
10 RING RNG-KBS1752102
11 SHADE SHD-KBS1752102
FIXTURE INSTALLATION
1. Attach the MOUNTING PLATE (1) unto the junction box using the MOUNTING SCREWS (2). This fixture is
designed to be mounted on standard round or octagon junction box. The junction box must be securely mounted
to the structure of the building.
2. Attach the Ground wire (Green) to the ground inside the outlet box (Generally green or bar copper wire) or the
GROUND SCREW (3) on the MOUNTING PLATE (1). NEVER CONNECT GROUND WIRE TO "HOT" WIRE!
FAILURE TO FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH!
3. Connect the white fixture lead to the neutral (Generally white) wire in the outlet box. Fasten the wires together
with an approved fastener (WIRE NUT) (4). Starting 1" below the fastener, tightly wrap the connection with
electrical tape so that the connections seals the end of the fastener. MAKE SURE THERE ARE NO EXPOSED
WIRE OF STRANDS THAT COULD CAUSE A DANGEROUS SHORT CIRCUIT!
4. Connect the black fixture leads to the hot (Generally black) wire in the junction box. Fasten the joined wires
same as previous step. NEVER REVERSE HOT AND NEUTRAL WIRES. FAILURE TO FOLLOW THIS
COULD RESULT IN SERIOUS INJURY OR DEATH!
5. Attach the FIXTURE ASSEMBLY (6) to the MOUNTING PLATE (1) and secure with the BOLT NUT (5).
6. Adjust the ARMS (8) and SWIVEL (9) to the desired Angle.
7.
8.
Screw the BULB (7) up into the SOCKET of the fixture.THIS FIXTURE IS RATED FOR 60 WATT TYPE G25
LAMP. DO NOT EXCEED THE RECOMMENDED WATTAGE!
Restore power to the outlet at the breaker or fuse box.
.
SPLIT
KBS1752803
INSTALLATION INSTRUCTIONS
www.hvlgroup.com
1
5
6
7
ITEM DESCRIPTION PART NUMBER
1MOUNTING PLATE HDW-KBS1752803
2MOUNTING SCREW HDW-KBS1752803
3GROUND SCREW HDW-KBS1752803
4WIRE NUT HDW-KBS1752803
5BOLT NUT HDW-KBS1752803
6FIXTURE ASSEMBLY FAS-KBS1752803
7BULB NOT INLCUDED
8ARMS FAS-KBS1752803
9SWIVEL FAS-KBS1752803
10
11
SHADE SHD-KBS1752102
2
3
4
89
ATTENTION PRUDENCE
DÉBRANCHEZ L'ALIMENTATION AVANT DE REMPLIR OU DE CÂBLER LE LUMINAIRE. LISEZ
COMPLÈTEMENT TOUTES LES INSTRUCTIONS AVANT DE COMMENCER L'INSTALLATION
POUR ÉVITER LE RISQUE D'INCENDIE OU D'ÉLECTROCUTION, LE LUMINAIRE DOIT ÊTRE INSTALLÉ
CONFORMÉMENT À TOUS LES CODES ÉLECTRIQUES/DE CONSTRUCTION NATIONAUX ET LOCAUX
APPLICABLES. L'INSTALLATION ET L'ENTRETIEN DE CET APPAREIL DOIVENT ÊTRE EFFECTUÉS PAR UN
ÉLECTRICIEN AGRÉÉ OU UN TECHNICIEN CERTIFIÉ FORMÉ EN USINE.
CALIFORNIE PROP 65 : CET APPAREIL D'ÉCLAIRAGE CONTIENT DES PRODUITS CHIMIQUES CONNUS PAR
L'ÉTAT DE CALIFORNIE POUR PROVOQUER LE CANCER, DES MALADIES CONGÉNITALES ET/OU D'AUTRES
DOMMAGES À LA REPRODUCTION. LAVER LES MAINS APRÈS UTILISATION.
RETIRER LE LUMINAIRE, LES PIÈCES ET LE(S) SAC(S) DE PIÈCES DU CARTON. AVANT DE JETER LE
CARTON, VÉRIFIEZ DOUBLE POUR VOUS ASSURER QUE TOUTES LES PIÈCES SONT TROUVÉES.
INSPECTER LE LUMINAIRE AVANT L'INSTALLATION POUR TOUT DOMMAGE AU LUMINAIRE.
GRADATION : LE LUMINAIRE PEUT ÊTRE CONTRLÉ PAR UN DISPOSITIF DE GRADATION MURALE. UTILISER
UNIQUEMENT UN GRADATEUR TRIAC/ÉLECTRONIQUE. ASSUREZ-VOUS QUE LE CARTON EST MARQUÉ
POUR UNE UTILISATION AVEC UNE SOURCE DE LUMIÈRE FLUORESCENTE À INCANDESCENTE COMPACTE
UNIQUEMENT. CEUX-CI PEUVENT ÊTRE FOURNIS PAR VOTRE DISTRIBUTEUR ÉLECTRIQUE LOCAL,
CENTRE À DOMICILE OU MAGASIN DE QUINCAILLERIE.
VEUILLEZ NETTOYER UNIQUEMENT AVEC UN CHIFFON DOUX ET SEC ! N'UTILISEZ PAS DE NETTOYANTS
Produkspesifikasjoner
| Merke: | Hudson Valley |
| Kategori: | Lettelse |
| Modell: | KBS1752803-AGB/SWH |
Trenger du hjelp?
Hvis du trenger hjelp med Hudson Valley KBS1752803-AGB/SWH still et spørsmål nedenfor, og andre brukere vil svare deg
Lettelse Hudson Valley Manualer
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
Lettelse Manualer
- Lettelse DeWalt
- Lettelse Hama
- Lettelse Neewer
- Lettelse Hazet
- Lettelse Philips
- Lettelse Schwaiger
- Lettelse IKEA
- Lettelse TP Link
- Lettelse Kogan
- Lettelse GoGEN
- Lettelse Nitecore
- Lettelse Kichler
- Lettelse Integral LED
- Lettelse ET2
- Lettelse Quoizel
- Lettelse Crystorama
- Lettelse Brennenstuhl
- Lettelse Varaluz
- Lettelse FIAP
- Lettelse Aputure
- Lettelse Media-tech
- Lettelse Gemini
- Lettelse Klein Tools
- Lettelse Schneider
- Lettelse Dainolite
- Lettelse Tesy
- Lettelse Martin
- Lettelse EMOS
- Lettelse Sharper Image
- Lettelse Fluval
- Lettelse Ryobi
- Lettelse Nanlite
- Lettelse BeamZ
- Lettelse Maxim
- Lettelse Brandson
- Lettelse Aplic
- Lettelse CSL
- Lettelse Bearware
- Lettelse NUVO
- Lettelse Milwaukee
- Lettelse OttLite
- Lettelse Showtec
- Lettelse Busch + Müller
- Lettelse V-Tac
- Lettelse Infinity
- Lettelse Nedis
- Lettelse Elation
- Lettelse Chauvet
- Lettelse Weeylite
- Lettelse ESYLUX
- Lettelse Livarno Lux
- Lettelse Casalux
- Lettelse Aqara
- Lettelse Beghelli
- Lettelse Middle Atlantic
- Lettelse Rosco
- Lettelse DeSisti
- Lettelse Astera
- Lettelse EXO
- Lettelse Profoto
- Lettelse GRE
- Lettelse Ikan
- Lettelse Ring
- Lettelse Perel
- Lettelse Blackburn
- Lettelse Sigma
- Lettelse Rayzr 7
- Lettelse Excello
- Lettelse Vimar
- Lettelse Genaray
- Lettelse Altman
- Lettelse Setti+
- Lettelse Kanlux
- Lettelse ARRI
- Lettelse Osram
- Lettelse Light4Me
- Lettelse GlobalTronics
- Lettelse Lume Cube
- Lettelse Digipower
- Lettelse ETC
- Lettelse Fiilex
- Lettelse Portman
- Lettelse ColorKey
- Lettelse Litepanels
- Lettelse Perfect Christmans
- Lettelse XQ-Lite
- Lettelse Govee
- Lettelse Peerless-AV
- Lettelse Heitronic
- Lettelse Obsidian
- Lettelse Blizzard
- Lettelse LUPO
- Lettelse Enttec
- Lettelse Fotodiox
- Lettelse GVM
- Lettelse Amaran
- Lettelse Halo
- Lettelse HQ Power
- Lettelse Kino Flo
- Lettelse Cateye
- Lettelse Maxxmee
- Lettelse Angler
- Lettelse Elan
- Lettelse Livex Lighting
- Lettelse Hinkley Lighting
- Lettelse Ranex
- Lettelse Fuzzix
- Lettelse COLBOR
- Lettelse Lucide
- Lettelse Paulmann
- Lettelse Melinera
- Lettelse Yongnuo
- Lettelse Audibax
- Lettelse Forte Lighting
Nyeste Lettelse Manualer
8 Januar 2025
8 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025