JBL Venue Stadium Bruksanvisning

JBL Høyttaler Venue Stadium

Les nedenfor 📖 manual på norsk for JBL Venue Stadium (4 sider) i kategorien Høyttaler. Denne guiden var nyttig for 4 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Last ned PDF

Side 1/4

TOUR, MONITOR, ARENA,

STAGE, STADIUM, VOICE,

BALCONY

JBL VENUE™

OWNER’S GUIDE

JBL VENUE™

For more than 60 years, JBL has been providing audio equipment for concert

halls, recording studios and movie theaters around the world and has become

the hands-down choice of leading recording artists and sound engineers.

With the JBL Venue Series, innovative technologies such as titanium-laminate-

dome tweeters, EOS™waveguides and PolyPlas™transducer reinforcement are

available to you. Enjoy!

UNPACKING THE SPEAKERS

If you suspect damage from transit, report it immediately to your dealer. Keep

the shipping carton and packing materials for future use.

PLACEMENT

NEVER drag the speaker to move it, as this will damage the spikes, the

feet and/or the wood cabinet itself. Always lift the speaker and carry it to its

new location.

CAUTION: Floorstanding (tower) loudspeakers have a high center

of gravity and may become unstable and tip over during events such as

earthquakes, or if rocked, tipped or improperly positioned. If this is a concern,

these speakers should be anchored to the wall behind them, using the same

procedures and hardware customary for anchoring bookcases and wall

units. The customer is responsible for proper installation and proper selection

of hardware.

STEREO

Before deciding where to place your speakers, survey your room and think

about placement, keeping the following points in mind, using Figure 1 as a

guide:

• For best results, place the speakers 6'– 8' (1.5m–2.5m) apart.

• Position each speaker so that the tweeter is approximately at ear level.

• Generally, bass output will increase as the speaker is moved closer to a wall

or corner.

• Refer to “Home Theater” below if you also plan to use the speakers for

home theater reproduction.

Figure 1. Experiment with speaker placement to obtain the best bass level and stereo

imaging in your room.

HOME THEATER

For front-channel use, place one speaker on the left and another on the right,

along either side of the television monitor. Since the speakers are magnetically

shielded, you can place them near the TV without worrying about the field dis-

torting the TV picture.

For surround-channel use, place speakers on bookshelves or stands alongside

the listening position. Tour and Balcony are also wall-mountable. Final place-

ment depends on room acoustics, availability of space and your listening pref-

erence (Figures 2 and 3).

In 6- or 7-channel configurations, place the rear channel(s) behind the listening

position, as shown in Figures 2 and 3.

NOTE: A JBL powered subwoofer will add impact and realism to both

music and film soundtracks. Contact your JBL dealer for recommendations

on subwoofer models for your application.

Figure 2. This overhead view shows a typical home theater plan. Left/right rear

channels are for a 7-channel system. The center rear channel is for a 6-channel system.

Figure 3. This figure shows an alternate layout, which may be more suitable for some

rooms. Left/right rear channels are for a 7-channel system. The center rear channel is

for a 6-channel system.

INSTALLING FEET

Balcony, Tour, Monitor, Arena

The supplied self-adhesive rubber feet may be attached to the bottom corners

of your speakers to protect your furniture.

Place pads here

Left Rear

Channel

JBL Subwoofer

(optional)

Right Rear

Channel

Center Rear

Channel

Couch

Left

F o tr n

Cha elnn

Left

S o durr un

Cha elnn

Left Rear

Cha elnn

Right Rear

Cha elnn

Ce te Rean r r

Cha elnn

Right

S o durr un

Cha elnn

Right

F o tr n

Cha elnn

Ce ten r

Cha elnn

JBL S bwoofeu r

(optio al)n

Listening Position

Left

Channel

Right

Channel

WALL-MOUNTING

Tour

The Venue Series Tour may be wall-mounted. The customer is responsible for

proper selection and use of mounting hardware (available through hardware

stores), to properly and safely wall-mount the speakers. These prod-

ucts are not intended for ceiling mounting.

Adjustable wall-mounting brackets are included.

Balcony

Important Safety Notes

• Proper selection of mounting hardware and installation of the wall brackets

are the responsibility of the customer.

• This product is not intended for ceiling mounting.

Two No. 8 round-head or pan-head screws should be used per loudspeaker.

The screw head should be between 5/16 inch (8mm) and 1/4 inch (6.3mm) in

diameter, and the screw should be at least 2 inches (50mm) in length.

When installing screws in any wall, always use properly selected wall

anchors. Attach two of the four self-adhesive rubber pads that came with the

Balcony loudspeaker to the back of the enclosure in the two bottom corners

so that the cabinet is spaced evenly from the wall. Select a suitable mounting

location on a wall. (The ceiling is not a suitable mounting location.)

Drill two pilot holes, appropriately sized for the specific self-tapping screw or

wall anchor that you will be using. The holes should be 8 inches (203mm)

apart. See Figure 1. The holes should be 3/4" (19mm) below where you want

the top of the enclosure to be positioned. Use a carpenter’s level to ensure

that the holes are even and that the speaker will mount on the level.

Install the two screws into either a wooden wall stud or anchor, and tighten

them until the back of each screw head is about 1/8 inch (3mm) from the wall.

See Figure 2. Install the loudspeaker by slowly moving the cabinet toward the

screws so that the screw heads clear the larger circular portion of the two

keyholes. Once both screw heads have entered the keyholes, the loudspeaker

should gently be lowered onto the screw shafts. Check that the loudspeaker is

firmly locked onto the screws by gently pulling the speaker down and forward.

WIRING THE SYSTEM

IMPORTANT: Make sure all equipment is

turned off before making any connections.

For speaker connections, use a high-quality speaker wire with polarity coding.

The side of the wire with a ridge or other coding is usually considered positive

polarity (i.e., +).

NOTE: If desired, consult your local JBL dealer about speaker wire and

connection options.

The speakers have coded terminals that accept a variety of wire connectors.

The most common connection is shown in Figure 4.

To ensure proper polarity, connect each terminal on the back of the amplifier+

or receiver to the respective (red) terminal on each speaker, as shown in+

Figure 5. Connect the –(black) terminals in a similar way. See the owner’s

guides that were included with your amplifier, receiver and television to

confirm connection procedures.

IMPORTANT: Do not reverse polarities

(i.e., + to

–

to +) when making connec-

tions. Doing so will cause poor imaging

and diminished bass response.

Figure 4. This figure shows how to connect bare wires to the terminals.

STANDARD CONNECTION

Figure 5. Wiring diagram shows polarity connections for one channel of a stereo or

home theater system.

FINAL ADJUSTMENTS

Check the speakers for playback, first by setting the system volume control

to a minimum level, and then by applying power to your audio system. Play a

favorite music or video segment and increase the system volume control to

a comfortable level.

NOTE: You should hear balanced audio reproduction across the entire fre-

quency spectrum. If not, check all wiring connections or consult the author-

ized JBL dealer from whom you purchased the system for more help.

The amount of bass you hear and the stereo-image quality will be affected by a

number of different factors, including the room’s size and shape, the construc-

tion materials used to build the room, the listener’s position relative to the

speakers, and the position of the speakers in the room.

Listen to a variety of music selections and note the bass level. If there is too

much bass, move the speakers away from nearby walls. Conversely, if you

place the speakers closer to the walls, there will be more bass output.

CARE OF YOUR SPEAKER SYSTEM

Each JBL Venue Series enclosure has a wood-grain-vinyl finish that does not

require any routine maintenance. When needed, use a soft cloth to remove

any fingerprints or dust from the enclosure or grille.

NOTE: Do not use any cleaning products or polishes on the cabinet

or grille.

See Chart 1/8"

(3mm)

Produkspesifikasjoner

Merke:	JBL
Kategori:	Høyttaler
Modell:	Venue Stadium

Trenger du hjelp?

Hvis du trenger hjelp med JBL Venue Stadium still et spørsmål nedenfor, og andre brukere vil svare deg

Ditt navn*

Din e-post*

Skriv spørsmålet ditt her

Høyttaler JBL Manualer

JBL PRX925 Bruksanvisning

26 Februar 2025

JBL 600GTi Bruksanvisning

21 Februar 2025

JBL 500GTi Bruksanvisning

21 Februar 2025

JBL Cinema Sound CS6100 Bruksanvisning

12 Februar 2025

JBL PartyBox Stage 320 Bruksanvisning

14 Januar 2025

JBL CVL28 Bruksanvisning

9 Januar 2025

JBL Tower X Marine MT10HLW Bruksanvisning

6 Januar 2025

JBL Control CM42AW Bruksanvisning

1 Januar 2025

JBL Performance P36AW Bruksanvisning

1 Januar 2025

JBL Balboa 30 Bruksanvisning

1 Januar 2025

Høyttaler Manualer

Nyeste Høyttaler Manualer

Metronic 477074 Bruksanvisning

27 Mars 2025

Induction Dynamics C2 Bruksanvisning

25 Mars 2025

ETON HEX 165 Bruksanvisning

20 Mars 2025

ETON PRW 50 Bruksanvisning

20 Mars 2025

ETON PRA 80 Bruksanvisning

20 Mars 2025

ETON PFX 16 Bruksanvisning

20 Mars 2025

SOUNDBOKS The Charger Bruksanvisning

20 Mars 2025

Streetz CM717 Bruksanvisning

20 Mars 2025

Streetz CM715 Bruksanvisning

20 Mars 2025

Streetz CM716 Bruksanvisning

20 Mars 2025