Ambient UMP III Bruksanvisning

Ambient Mikrofon UMP III

Les nedenfor 📖 manual på norsk for Ambient UMP III (4 sider) i kategorien Mikrofon. Denne guiden var nyttig for 3 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/4
Schleissheimer Straße 181 C | DE +49 89 360 55 10 80797 Munich | phone -0 | www.ambient.de/en | info@ambient.de
© 2020, Ambient Recording GmbH
Universal Microphone Power Supply
Instruction Manual
Schleissheimer Straße 181 C | DE +49 89 360 55 10 80797 Munich | phone -0 | www.ambient.de/en | info@ambient.de
© 2020, Ambient Recording GmbH
P reparing the UMP III
- P ush the battery lever on the bottom in and slide right (direction MIC connector)
- Insert battery with the polarity protection gap to the left when looking at the
front
- Close the door and push back to the left
Power on
Plug in the Mic In cable. The device can only be switched on with the Mic In cable
connected.
Press the button until the LED turns from red to green, release. The LED will now display
the current power setting.
Schleissheimer Straße 181 C | DE +49 89 360 55 10 80797 Munich | phone -0 | www.ambient.de/en | info@ambient.de
© 2020, Ambient Recording GmbH
Power settings LED color:
Blue (default): 48V Phantom
White: 12V Phantom
Yellow: 12V T- Power
Red: Low battery, approx. 15min operation left
Note: Default setting is 48V phantom, but the unit will retain a previously selected mode. To
prevent damage caused by improper power mode, check the current active setting matches
your microphone before connecting it.
Check the setting while unit is on briefly tap the button. The Led will blink in the color of
the active setting.
Changing the power setting
Alternate between 48V and 12V Phantom briefly tap the button twice. The unit will light :
up the setting it would switch to. If you want to confirm, tap while LED is lit, to cancel,
wait. The unit will now blink 3 times in the color of the now active mode.
Enabling T-Power: tap 3 times. The LED will light up yellow. To confirm, tap the button
while LED is lit yellow. The un will blink 3 times yellow to indicate Tit -Power is now
activated.
Disabling T-Power: tap button twice. The Led will light up blue. To confirm selection tap
button while LED is lit. The unit will blink 3 times blue to indicate 48V Ph is now
activated.

Produkspesifikasjoner

Merke: Ambient
Kategori: Mikrofon
Modell: UMP III

Trenger du hjelp?

Hvis du trenger hjelp med Ambient UMP III still et spørsmål nedenfor, og andre brukere vil svare deg




Mikrofon Ambient Manualer

Mikrofon Manualer

Nyeste Mikrofon Manualer