Electro Harmonix Cock Fight Bruksanvisning

Electro Harmonix Ikke kategorisert Cock Fight

Les nedenfor 📖 manual på norsk for Electro Harmonix Cock Fight (4 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 2 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Last ned PDF

Side 1/4

Cock Fight

Cocked Talking Wah with Fuzz

Congratulations on your purchase of the Electro-Harmonix , a dual-Cock Fight

filter fuzz box. The contains two different expressive filters: a Cock Fight

traditional wah pedal filter CRY, and a formant filter TALK used for vowel sounds.

The also has a fuzz section that can be added before or after the Cock Fight

filter section, or taken out of the signal path. The BOTTOM and BIAS controls

allow additional tone shaping possibilities. Connect an expression pedal or a

control voltage to the expression input jack for even more sound control.

WARNING: Your Cock Fight comes equipped with an Electro-Harmonix 9.6DC-200BI

power supply (same as used by Boss®

& Ibanez®: 9.6 Volts DC 200mA). The Cock Fight

requires mA at 9VDC with a center negative plug. Using the wrong adapter or a plug 40

with the wrong polarity may damage your Cock Fight and void the warranty.

-QUICK SETUP-

Connect the output plug of the supplied power adapter to the 9V power jack.

Plug your instrument in the INPUT jack; connect your amp to the OUTPUT jack.

Set VOL to about three o’clock, FREQ to max, BOTTOM to min, left switch to

CRY, and right switch to FUZZ OFF. Press the footswitch so that the LED light is

lit. With the effect turned on, you will hear a slight boost in volume as well as a

brighter sound. Adjust the FREQ knob to dial in the cocked wah sound to your

taste. Connect an optional expression pedal to vary the frequency of the filter

continuously as you would with a traditional wah pedal.

- CONTROLS -

VOL Knob – Use this knob to adjust the master output volume.

FREQ Knob – Use to adjust the frequency of the filter selected by the CRY/TALK

toggle switch.

TONE Knob – Use to blend between a darker fuzz and brighter fuzz sound.

DRIVE Knob – Adjust to set the amount of fuzz.

BOTTOM Knob – BOTTOM is a low frequency boost control that is slightly

above unity gain when set fully clockwise. Set fully counterclockwise to remove

the BOTTOM circuit from the signal path. TIP: When used with a bass guitar or

other low frequency sources, the BOTTOM adjustment can help retain the

bottom end typically lost with most wah pedals.

CRY/TALK Toggle Switch – The UP position selects the CRY setting. CRY

simulates the type of filter found in a typical wah pedal circuit. The DOWN

position selects the TALK setting. This setting as its name implies produces — —

throaty/vocal vowel sounds.

PRE/FUZZ OFF/POST Toggle Switch – The PRE position places the fuzz

before the filter. Use this position for a vintage Hendrix vibe. FUZZ OFF removes

the fuzz from the signal path. The POST position places the fuzz after the filter

and yields a more modern sound.

BIAS Knob – This knob controls the amount of bias voltage supplied to one of

the transistors in the fuzz circuit. Turn the BIAS knob fully clockwise to supply a

nominal voltage and create a normal fuzz sound. Turn the bias control down

(counterclockwise) to decrease the bias voltage to get the “dying battery” sound.

This type of sound is characterized by a decrease in sustain and by notes that

get choked off you play with less force as .

Footswitch & Status LED – The Footswitch toggles between effect and

buffered bypass. The status LED lights when in effect mode.

INPUT Jack – This ¼” jack is the audio input for the Cock Fight.

OUTPUT Jack – This ¼” jack is the audio output for the Cock Fight.

EXP Jack The expression/CV input controls the frequency knob. The position –

of the FREQ knob sets the maximum sweep range of the expression/CV input.

Expression input jack accepts a TRS expression pedal connector or a Tip-Sleeve

0-5V control voltage input. The expression pedal should ideally use a 10k

potentiometer with linear taper. It must have the wiper connected to TIP and

toe-down connected to RING. Some manufacturers do not conform to ’ pedals

this convention and require a special cable/adaptor to swap RING and TIP.

Suggested Expression Pedals: EHX Expression Pedal, M-Audio® -P, MoogEX ® EP-

2 & EP-3, Roland® -5 or BossEV ® -500L. FV

- CHANGING THE BATTERY -

To change your 9-volt battery, you must remove the 4 screws on the bottom of

the Cock Fight. Once the screws are removed, take off the bottom plate and

change the battery. Please do not We recommend alkaline batteries9V .

touch the circuit board while the bottom plate is off or you risk damaging a

component.

FUZZ ON/OFF Switch –On the PCB there is a small DIP switch that changes

FUZZ OFF to FUZZ THROUGH mode. In FUZZ THROUGH mode the filter section

is bypassed and removed from the signal path. In this mode the knobs FREQ,

BOTTOM and switch CRY/TALK have no effect on the sound.

-NOTES AND SPECIFICATION-

• The Cock Fight utilizes a high quality buffered bypass.

•  The input impedance is 2M2 .

•  The output impedance is 470 .

• The Cock Fights’ current draw is 35mA.

- WARRANTY INFORMATION -

Please register online at http://www.ehx.com/product-registration or complete

and return the enclosed warranty card within 10 days of purchase. Electro-

Harmonix will repair or replace, at its discretion, a product that fails to operate

due to defects in materials or workmanship for a period of one year from date of

purchase. This applies only to original purchasers who have bought their product

from an authorized Electro-Harmonix retailer. Repaired or replaced units will then

be warranted for the unexpired portion of the original warranty term.

If you should need to return your unit for service within the warranty period,

please contact the appropriate office listed below. Customers outside the regions

listed below, please contact EHX Customer Service for information on warranty

repairs at info@ehx.com or +1- - -8300. USA and Canadian customers: 718 937

please obtain a (RA#) from EHX Customer Return Authorization Number

Service before returning your product. Include with your returned unit a written  

description of the problem as well as your name, address, telephone number, e-

mail address, RA# and a copy of your receipt clearly showing the purchase date.

United States & Canada

EHX CUSTOMER SERVICE

ELECTRO-HARMONIX

c/o NEW SENSOR CORP.

47-50 33RD STREET

LONG ISLAND CITY, NY 11101

Tel: 718- - 937 8300

Email: info@ehx.com

Europe

JOHN WILLIAMS

ELECTRO-HARMONIX UK

13 CWMDONKIN TERRACE

SWANSEA SA2 0RQ

UNITED KINGDOM

Tel: +44 179 247 3258

Email: electroharmonixuk@virginmedia.com

To hear demos on all EHX pedals visit us on the web at www.ehx.com

Email us at info@ehx.com

Produkspesifikasjoner

Merke:	Electro Harmonix
Kategori:	Ikke kategorisert
Modell:	Cock Fight

Trenger du hjelp?

Hvis du trenger hjelp med Electro Harmonix Cock Fight still et spørsmål nedenfor, og andre brukere vil svare deg

Ditt navn*

Din e-post*

Skriv spørsmålet ditt her

Ikke kategorisert Electro Harmonix Manualer

Electro Harmonix Canyon Echo Bruksanvisning

22 Oktober 2024

Electro Harmonix The Worm Bruksanvisning

21 Oktober 2024

Electro Harmonix Holy Grail Max Bruksanvisning

16 Oktober 2024

Electro Harmonix Cock Fight Plus Bruksanvisning

16 Oktober 2024

Electro Harmonix Cock Fight Bruksanvisning

16 Oktober 2024

Ikke kategorisert Manualer

Nyeste Ikke kategorisert Manualer

Daewoo Cyclone Essential FLR00038 Bruksanvisning

28 Oktober 2024

IFM SU6631 Bruksanvisning

28 Oktober 2024

IFM SU7031 Bruksanvisning

28 Oktober 2024

IFM SV8051 Bruksanvisning

28 Oktober 2024

Daewoo AVS1464 Bruksanvisning

28 Oktober 2024

IFM PT5300 Bruksanvisning

28 Oktober 2024

IFM KTE301 Bruksanvisning

28 Oktober 2024

IFM OVP810 Bruksanvisning

28 Oktober 2024

IFM SF0516 Bruksanvisning

28 Oktober 2024

IFM TSM701 Bruksanvisning

28 Oktober 2024