Hinkley Lighting Hadley 3302AN-CL Bruksanvisning
Hinkley Lighting
Lettelse
Hadley 3302AN-CL
Les nedenfor 📖 manual på norsk for Hinkley Lighting Hadley 3302AN-CL (2 sider) i kategorien Lettelse. Denne guiden var nyttig for 2 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere
Side 1/2
assembly instructions
Family: Hadley Item No. 3302
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Prepare ge rap m st (A) for scmounting by threading two rews (B)
provided into back of gull wing bracket of gem strap (A) - see Drawing 1.
• Be sure the holes into which the screws are threaded tch the spacing of holes ma (D)
in the ceiling pan (1) - see Drawings 1 and 2.
2. Mount ge rap m st (A) to junction box (J), using the two 1” rews not provided sc (C)
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet and follow all instructions to make all necessary wiring connections. (I.S. 18)
Then refer back to this sheet to continue installation of this fixture.
1. Hang the fixture by slipping the holes in the ceiling pan over the screws (D) (1) (B)
in the mounting strap - see .(A) Drawing 2
2. Thread on ball knobs to secure fixture to the ceiling.(F)
1. Prior to installing glass, fixture should be lamped.
2. To install glass lay glass into ring (2), (3).
3. Slip the 3 holes (H) of ring over the threaded studs of the uprights and hold (G) (UP)
in position.
4. Thread decorative knobs (4) onto end of studs (G) and tighten to secure glass.
*** The construction of this fixture will be accomplished by first mounting the
mounting strap to the junction box, making all necessary electrical connections,
hanging the fixture from the ceiling, and then installing the glass.
start here
3302
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Fixture Mounting
Drawing 3 - Glass Installation
B
D
F
J
C
A
1
Drawing 1 - Strap Detail
B
(side view)
gull wing
bracket
B
01.01.13
2
3
4
H
UP
G
H I N K L E Y L I G H T I N G 33000 Pin O a k Parkw a y Avon Lake, OH 44012 800.446.5539 / 4 4 0 .653.5 5 00 hinkl e ylighting.com
T24 JA8-2016
I.S. 18 wiri roun g n onsng g din i st ctiru
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
w t t siring ins ruc ion
Indoor Fixtures
1. Connect positive supply wire (A) (typically black or the smooth, unmarked
side of the two-conductor cord) to positive fixture lead with appropriately (B)
sized twist on connector - see .Drawings 1 or 2
2. Connect negative supply wire (typically white or the ribbed, marked (C)
side of the two-conductor cord) to negative fixture lead .(D)
3. Please refer to the below to complete all grounding instructions
electrical connections.
Outdoor Fixtures
1. Connect positive supply wire (A) (typically black or the smooth unmarked
side of the two-conductor cord) to positive fixture lead with appropriately (B)
sized twist on connector - see . Drawings 2 or 3
2. Connect negative supply wire (typically white or the ribbed, marked (C)
side of the two-conductor cord) to negative fixture lead .(D)
3. Cover open end of connectors with silicone sealant to form a watertight seal.
• If installing a wall mount fixture, use caulk to seal gaps between the fixture
mounting plate (backplate) and the wall. This will help prevent water from
entering the outlet box. If the wall surface is lap siding, use caulk and a
fixture mounting platform specially.
4. Please refer to the below to complete all grounding instructions
electrical connections.
gr r sounding inst uction
Flush Mount Fixtures
For positive grounding in a 3-wire electrical system, fasten the fixture ground
wire (typically copper or green plastic coated) to the fixture mounting strap (E) (1)
with the ground screw - see . (2) Drawing 1
Note: On straps for screw supported fixtures, first install the two mounting screws in strap.
Any remaining tapped hole may be used for the ground screw.
Chain Hung Fixtures
Loop fixture ground wire (typically copper or green plastic coated) under the (E)
head of the ground screw on fixture mounting strap and connect to the (2) (1)
loose end of the fixture ground wire directly to the ground wire of the building
system with appropriately sized twist-on connectors - see .Drawing 2
Post-Mount Fixtures
Connect fixture ground wire (typically copper or green plastic coated) to power (E)
supply ground with appropriately sized twist-on connector inside post. Cover open
end of connector with silicone sealant to form a watertight seal - see .Drawing 3
Drawing 1 - Flush Mount
Drawing 2 - Chain Hung
supply wire
fixture leads
twist-on
connectors
Drawing 3 - Post-Mount
twist-on
connectors
1
A CC
B D
supply wire
fixture leads
A C
B D
1
2
supply wire
fixture leads
A C
B D
twist-on
connectors
E
2
E
E
E
E
I.S. 18
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
Produkspesifikasjoner
| Merke: | Hinkley Lighting |
| Kategori: | Lettelse |
| Modell: | Hadley 3302AN-CL |
Trenger du hjelp?
Hvis du trenger hjelp med Hinkley Lighting Hadley 3302AN-CL still et spørsmål nedenfor, og andre brukere vil svare deg
Lettelse Hinkley Lighting Manualer
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
5 Januar 2025
Lettelse Manualer
- Lettelse DeWalt
- Lettelse Hama
- Lettelse Neewer
- Lettelse Hazet
- Lettelse Philips
- Lettelse Schwaiger
- Lettelse IKEA
- Lettelse TP Link
- Lettelse Kogan
- Lettelse GoGEN
- Lettelse Nitecore
- Lettelse Kichler
- Lettelse Integral LED
- Lettelse ET2
- Lettelse Quoizel
- Lettelse Crystorama
- Lettelse Brennenstuhl
- Lettelse Varaluz
- Lettelse FIAP
- Lettelse Aputure
- Lettelse Media-tech
- Lettelse Gemini
- Lettelse Klein Tools
- Lettelse Schneider
- Lettelse Dainolite
- Lettelse Tesy
- Lettelse Martin
- Lettelse EMOS
- Lettelse Sharper Image
- Lettelse Fluval
- Lettelse Ryobi
- Lettelse Nanlite
- Lettelse BeamZ
- Lettelse Maxim
- Lettelse Brandson
- Lettelse Aplic
- Lettelse CSL
- Lettelse Bearware
- Lettelse NUVO
- Lettelse Milwaukee
- Lettelse OttLite
- Lettelse Showtec
- Lettelse Busch + Müller
- Lettelse V-Tac
- Lettelse Infinity
- Lettelse Nedis
- Lettelse Elation
- Lettelse Chauvet
- Lettelse Weeylite
- Lettelse ESYLUX
- Lettelse Livarno Lux
- Lettelse Casalux
- Lettelse Aqara
- Lettelse Beghelli
- Lettelse Middle Atlantic
- Lettelse Rosco
- Lettelse DeSisti
- Lettelse Astera
- Lettelse EXO
- Lettelse Profoto
- Lettelse GRE
- Lettelse Ikan
- Lettelse Ring
- Lettelse Perel
- Lettelse Blackburn
- Lettelse Sigma
- Lettelse Rayzr 7
- Lettelse Excello
- Lettelse Vimar
- Lettelse Genaray
- Lettelse Altman
- Lettelse Setti+
- Lettelse Kanlux
- Lettelse ARRI
- Lettelse Osram
- Lettelse Light4Me
- Lettelse GlobalTronics
- Lettelse Lume Cube
- Lettelse Digipower
- Lettelse ETC
- Lettelse Fiilex
- Lettelse Portman
- Lettelse ColorKey
- Lettelse Litepanels
- Lettelse Perfect Christmans
- Lettelse XQ-Lite
- Lettelse Govee
- Lettelse Peerless-AV
- Lettelse Heitronic
- Lettelse Obsidian
- Lettelse Blizzard
- Lettelse LUPO
- Lettelse Enttec
- Lettelse Fotodiox
- Lettelse GVM
- Lettelse Amaran
- Lettelse Halo
- Lettelse HQ Power
- Lettelse Kino Flo
- Lettelse Cateye
- Lettelse Maxxmee
- Lettelse Angler
- Lettelse Livex Lighting
- Lettelse Ranex
- Lettelse Fuzzix
- Lettelse COLBOR
- Lettelse Lucide
- Lettelse Paulmann
- Lettelse Melinera
- Lettelse Yongnuo
- Lettelse Audibax
- Lettelse Hudson Valley
- Lettelse Forte Lighting
Nyeste Lettelse Manualer
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025
7 Januar 2025