Induro GHB2C Bruksanvisning

Induro Stativ GHB2C

Les nedenfor 📖 manual på norsk for Induro GHB2C (1 sider) i kategorien Stativ. Denne guiden var nyttig for 3 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Last ned PDF

Side 1/1

GH-SERIES GIMBAL HEAD

OPERATING INSTRUCTIONS

Thank you for making Induro your choice for

professional photographic gear. Your Induro gear

is manufactured to provide years of dependable

service. In order to obtain optimum satisfaction

and performance we suggest that you carefully

read these instructions and provide them to

anyone who may also use your Induro gear.

OPERATION (FIGURE 4)

The GH-Series Gimbal Heads are

professional devices and once adjusted for

typical operation only require two controls.

Slightly loosen both the Tilt Knob and Pan

Knob. Then aim the camera at the subject

and tighten both Knobs to lock.

If you’re photographing and following action,

you may keep both Knobs loose and take

advantage of the stability offered by the

Gimbal Head. Lock the Knobs when you

are ﬁnished or are not ﬁrmly holding the

Camera/Lens.

FOR OPTIMUM RESULTS: Adjust the balance

and Camera/Lens positioning with the weight

capacity, temperature and conditions under

which the Gimbal Head will be used.

NOTE: Do not over tighten any Locking

Knobs or try to move the Camera/Lens once

tightened as this could damage the Gimbal

Head locking mechanism.

USER NOTICE

cDo not exceed the maximum speciﬁed load

capacity (see speciﬁcations on the package

label or visit www.Induro.com).

cAlways ensure that all Ballhead locks are

tightly engaged before mounting any gear.

cDo not use any Ballhead below

temperatures of −4°F or above +158°F

(−20°C / +70°C).

cAlways clean and dry any Ballhead after

it has been exposed to wet, dusty, sandy

or salty conditions. Your Ballhead is not

recommended for use in salt water. If

required, clean Ballhead using a mild soap

solution applied with a soft cloth, rinse

with fresh water and dry with soft towel.

Remove any dust, dirt or sand from all

locks and all moving parts.

cDo not leave any Ballhead in the sun

for prolonged periods and avoid high

temperature exposure.

cAvoid leaving any Tripod or Monopod

unattended in areas where people could

trip over the gear and get hurt.

cRemove camera, lens, and all gear from

any Tripod or Monopod when transporting.

cFor your safety, don’t let your Induro

gear come in contact with any electrical

power source.

Specifications and design are subject to change without notice.

All tradenames, logos, and brand references are the respective trademarks of their owners.

Produkspesifikasjoner

Merke:	Induro
Kategori:	Stativ
Modell:	GHB2C

Trenger du hjelp?

Hvis du trenger hjelp med Induro GHB2C still et spørsmål nedenfor, og andre brukere vil svare deg

Ditt navn*

Din e-post*

Skriv spørsmålet ditt her

Stativ Induro Manualer

Induro PHQ3 Bruksanvisning

2 April 2025

Induro BHD2 Bruksanvisning

2 April 2025

Induro GHB1 Bruksanvisning

2 April 2025

Induro BHL1S Bruksanvisning

2 April 2025

Induro BHL2S Bruksanvisning

2 April 2025

Induro BHD3 Bruksanvisning

2 April 2025

Induro GHB2C Bruksanvisning

2 April 2025

Induro BHL3S Bruksanvisning

2 April 2025

Stativ Manualer

Nyeste Stativ Manualer

Proaim VI-GLDE-01 Bruksanvisning

3 April 2025

Oben CT-3431 Bruksanvisning

3 April 2025

Oben AC-1451 Bruksanvisning

3 April 2025

Kern SFB-A01 Bruksanvisning

2 April 2025

Sirui SH-15 Bruksanvisning

2 April 2025

Lowel CGA-40C Bruksanvisning

2 April 2025

Lowel CGH-25B Bruksanvisning

2 April 2025

Sachtler FSB 14T Mk II Bruksanvisning

2 April 2025

Proaim P-MLAK-01 Bruksanvisning

2 April 2025

Proaim LV-SCFH-01 Bruksanvisning

2 April 2025