Kendall Howard 5500-3-004-35 Bruksanvisning

Kendall Howard Kant 5500-3-004-35

Les nedenfor 📖 manual på norsk for Kendall Howard 5500-3-004-35 (2 sider) i kategorien Kant. Denne guiden var nyttig for 2 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/2
®
Tools Needed:
Step 1: Step 2:
Step 3:
Screwdriver
What’s Included:
QTY 1: Right
Leg Assembly
QTY 1: Le
Leg Assembly
QTY 1: Modesty
Panel QTY 1: Table Top
QTY 4:
Levelers
QTY 4:
End Caps
QTY 1: Modesty
Panel Grommet
QTY 1:
Surface
Grommet
QTY 25:
1/4-20”
Screws
Step 4:
A. Posion table top with smooth surface facing down.
B. -Line up leg assemblies with pre drilled hole paern.
(Note: Shorter side of legs face back of the table.)
C. - Fasten to table top with 1/4 20” screws.
*If installing the Cable Management Enclosure, leave out
the back two screws in the legs.
A. Aach modesty panel to the back edge of the right and le
leg assemblies. (Ensure the grommet opening is closest to
the work surface.)
B. - Fasten with 1/4 20” screws.
*If not installing the Cable Management Enclosure, ll in
addional threaded holes in modesty panel with addional
screws.
*If installing the
Cable Management
Enclosure, proceed
to mount that to the
modesty panel
before assembling
the panel to the
training table.
A. Insert levelers into the threaded inserts in the boom
of the leg assemblies.
B. Insert end caps into base of each leg.
A. Set the training table height on each leg assembly by
unscrewing and sliding the leg to the desired posion.
B. Re- insert screws to secure.

Produkspesifikasjoner

Merke: Kendall Howard
Kategori: Kant
Modell: 5500-3-004-35

Trenger du hjelp?

Hvis du trenger hjelp med Kendall Howard 5500-3-004-35 still et spørsmål nedenfor, og andre brukere vil svare deg