Kramer KDOCK-1/2/3-HOLDER Bruksanvisning

Kramer Ikke kategorisert KDOCK-1/2/3-HOLDER

Les nedenfor 📖 manual på norsk for Kramer KDOCK-1/2/3-HOLDER (4 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 2 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/4
www.kramerAV.com
info@kramerel.com
Installation Instructions
MODEL:
KDOCK-1/2/3-HOLDER
KDOCK-4-HOLDER
P/N:
2 9 0 0 - 3 0 1 5 2 2 QS
Rev:
SAFETY WARNING
Disconnect the unit from the power supply before opening and servicing
For the latest information products a list Kramer distributors, visit on our and of our
Web site where updates to these installation instructions may be found.
We welcome your questions, comments, and feedback.
2
KDOCK-1/2/3-HOLDER
KDOCK-1/2/3-HOLDER
Congratulations on purchasing your Kramer KDOCK-1/2/3-HOLDER / KDOCK-4-HOLDER
for safely securing USB-C Hub Multiport Adapters . KDock below or a surfaceon
This document describes how to secure the and the KDOCK-1/2/3-HOLDER
KDOCK-4-HOLDER to a surface.
Installing KDOCK-1/2/3-HOLDER the
KDOCK-1/2/3-HOLDER can be installed either under or above a surface. In this example,
it is installed under a table.
To secure the KDOCK-1/2/3-HOLDER under a table:
1. Insert the KDock device into the clamp, in-between the rubber pads.
2. Insert a washer (supplied) and then a nut (supplied) onto each of the studs and tighten.
3. Check the location under the table where you want to install the device and mark the
location for the two installation screws (supplied).
4. Use the two installation screws to secure the under the table.
KDOCK-1/2/3-HOLDER
KDOCK-1/2/3-HOLDER is secured under a table.
Installation Instructions
3
Installing KDOCK-4-HOLDER the
KDOCK-4-HOLDER can be installed either under or above a surface. In this example, it is
installed a table. Note that when it is installed under, the ip-up device holder cannot be on
used.
To secure the KDOCK-4-HOLDER a table: on
1. Place the device on the surface, at the correct location. KDock-4
2. Place the over the device. KDOCK-4-HOLDER
3. Insert the four screws and secure the to the table. KDOCK-4-HOLDER
KDOCK-4-HOLDER is secured on a table.

Produkspesifikasjoner

Merke: Kramer
Kategori: Ikke kategorisert
Modell: KDOCK-1/2/3-HOLDER

Trenger du hjelp?

Hvis du trenger hjelp med Kramer KDOCK-1/2/3-HOLDER still et spørsmål nedenfor, og andre brukere vil svare deg




Ikke kategorisert Kramer Manualer

Ikke kategorisert Manualer

Nyeste Ikke kategorisert Manualer