Renkforce FT007TH Bruksanvisning

Les nedenfor 📖 manual på norsk for Renkforce FT007TH (6 sider) i kategorien Værstasjon. Denne guiden var nyttig for 3 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/6
FT007TH Thermo-Hygrometer Sensor
User Manual
1 Introduction
Thank you for your purchase of the FT007TH Thermo-Hygrometer Sensor. The following user guide
provides step by step instructions for installation, operation and troubleshooting.
2. Thermo-Hygrometer Sensor.
1. Remove the battery door on the back of the sensor by removing the set screw, as shown in
Figure 1 .
Figure 1
2. inserting the batteries, locate the dip switches on the inside cover of the lid of the BEFORE
transmitter.
Figure 2 displays all four switches in the OFF position (factory default setting).
Figure 2
3. The FT007TH supports up to eight Channels. To set each channel number Channel Number:
(the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1.
4. Temperature Units of Measure: To change the transmitter display units of measure (°F
vs. °C), change Dip Switch 4, as referenced in Table 1.
DIP SWITCH FUNCTION
1 2 3 4
DOWN
DOWN
DOWN
---
Channel 1
DOWN
DOWN
UP
---
Channel 2
DOWN
UP
DOWN
---
Channel 3
DOWN
UP
UP
---
Channel 4
UP
DOWN
DOWN
---
Channel 5
UP
DOWN
UP
---
Channel 6
UP
UP
DOWN
---
Channel 7
UP
UP
UP
---
Channel 8
---
---
DOWN
---
---
UP
°C
Table 1
5. Insert two AAA batteries.
6. After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and
then flash once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting data.
7. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are on
the display, as shown in Figure 3.
Figure 3
(1) temperature
(2) temperature units ( °F vs. °C)
(3) channel number

Produkspesifikasjoner

Merke: Renkforce
Kategori: Værstasjon
Modell: FT007TH

Trenger du hjelp?

Hvis du trenger hjelp med Renkforce FT007TH still et spørsmål nedenfor, og andre brukere vil svare deg