Watson VM-198-B-HLE Bruksanvisning

Watson Ikke kategorisert VM-198-B-HLE

Les nedenfor 📖 manual på norsk for Watson VM-198-B-HLE (4 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 3 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/4
Thank you for choosing Watson Pro
Please read this user manual carefully, and keep
it for reference before using the battery.
VM-168-HLE-RED
AM/VM-198-B-HLE
Buddy System
Li-ion Battery with LED
and 3-Stud or V-Mount
SAFETY INSTRUCTIONS
Make sure the battery is fully charged before use.
When not in use, remove the battery from its device. Some
electronic equipment will draw current even when the switch is off.
Do not short-circuit the terminals. This battery is protected with
an internal self-resetting fuse, but short circuits may still cause
severe damage to the battery.
Do not attempt to open the battery case under any circumstances.
Do not remove the battery from any equipment that is powered on.
Always power off your equipment before removing the battery.
Use the battery under proper environmental conditions: 14°F to
122°F (-10°C to 50°C) with a Relative Humidity (RH) less than 85%.
The battery may be warm during use or recharging. This is normal.
The battery should be charged up to 40% for storage longer than
one month, and should be charged every 6 months.
Keep the battery away from fire, heat, and high pressure.
Do not expose the battery to rain or moisture.
Do not drop the battery or subject it to strong shocks.
Keep this unit away from water and any flammable gases or liquids.
Clean the battery and terminals with only a clean, soft,
and dry cloth.
When operation time has noticeably decreased, the battery may
need to be replaced.
Keep this product away from children.
Store the battery in a cool, dry place.
IMPORTANT
You must connect both halves
of the buddy system battery in
order for it to be operational.
You can only connect the
halves of buddy system
batteries with matching
serial numbers.
After assembling the two
halves, the 100% battery
level LED will light up for
three seconds. Then, the
battery level will display the
current charge amount.
OVERVIEW
. Battery-level check button
. Battery-level LED meter
Shows remaining capacity of
the battery. When capacity
reaches less than 9%, the
bottom LED will flash.
Slide lock
. D-tap output
12 V, 10 A max
. USB output
Press the battery-level check
button to start charging or to
power your USB device.
1. Mounting interface: 3-stud
or V-mount
1
2
3
4
5
6
4
2
3
5
6
1

Produkspesifikasjoner

Merke: Watson
Kategori: Ikke kategorisert
Modell: VM-198-B-HLE

Trenger du hjelp?

Hvis du trenger hjelp med Watson VM-198-B-HLE still et spørsmål nedenfor, og andre brukere vil svare deg




Ikke kategorisert Watson Manualer

Ikke kategorisert Manualer

Nyeste Ikke kategorisert Manualer