DPA 4017B Bruksanvisning
Les nedenfor 📖 manual på norsk for DPA 4017B (2 sider) i kategorien Mikrofon. Denne guiden var nyttig for 3 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere
Side 1/2
4017B Shotgun Microphone
A combination of the MMC4017 microphone capsule and the MMP-B
preamplifier with filters, the 4017B Shotgun Microphone is part of the
Pencil Microphone Series
Performance
The supplied calibration chart shows the specially tailored individual
frequency response of the MMC4017 capsule, measured with a linear
MMP-A preamp.
Typical on- and o-axis frequency response of 4017B (MMC4017+MMP-B)
Filters
DPA 4017B features a permanent third-order 50 Hz low cut and two
switchable filters, which are controlled at the switchable rings. No tools
are needed to activate the filters, use fingers only.
High boost: a 4 dB boost at 8 kHz.
Low cut: a first order (6 dB/oct) bass roll-o below 120 Hz.
Frequency responses of switching filters on 4017B
dpamicrophones.com/4017
DPI-4017B-QG
Service & repair
If you are not satisfied with the characteristics exhibited by this product, please contact your nearest DPA
Microphones representative for support.
Warranty
4017B is covered by a five-year limited warranty.
CE marking
This product conforms with all relevant directives approved by the European Commission.
20 Hz 50 100 200
500
1 kHz 2 5 10 20 40
dB
10
-10
-20
-30
0
0°
30°
60°
90°
140
°
20 Hz 50 100 200
500
1 kHz 2 5 10 20 40
dB
10
-10
-20
-30
0
Without low cut
With high boost +4 dB @ 8 kHz
Without high boost
With low cut
@ 120 Hz
6 dB / oct
Specifications
Directional pattern
Supercardioid, lobe-shaped
Principle of operation
Pressure gradient, with interference tube
Capsule type
Pre-polarized condenser
Frequency response
20 Hz - 20 kHz, permanent third order high pass filter at 50 Hz
Eective frequency range, ± 2 dB, at 60 cm (23.6 in)
70 Hz - 18 kHz with typ. 3 dB soft boost at 15 kHz
Sensitivity, nominal, ± 2 dB at 1 kHz
19 mV/Pa, -34.4 dB re 1 V/Pa
Equivalent noise level, A-weighted
Typ. 13 dB(A) re. 20 µPa (max. 15 dB(A))
Switchable attenuator, filters etc.
High boost: +4 dB at 8 kHz. Low cut: First order filter, below 120 Hz
Rated output impedance
< 100 Ω
Output balance principle
Signal balanced
Common Mode Rejection Ratio (CMRR)
> 40 dB
Power supply (for full performance)
P48 (Phantom Power)
Current consumption
4.5 mA
Polarity
+V at Pin 2 for positive sound pressure
Connector
XLR-3M. Pin 1: Shield, Pin 2: signal + phase, Pin 3: signal – phase
Weight
68 g (2.4 oz)
Operating temperature range
-40 °C to 45 °C (-40 °F to 113 °F)
Relative humidity
Up to 90%
Produkspesifikasjoner
| Merke: | DPA |
| Kategori: | Mikrofon |
| Modell: | 4017B |
Trenger du hjelp?
Hvis du trenger hjelp med DPA 4017B still et spørsmål nedenfor, og andre brukere vil svare deg
Mikrofon DPA Manualer
22 Oktober 2024
22 Oktober 2024
22 Oktober 2024
19 Oktober 2024
17 Oktober 2024
17 Oktober 2024
Mikrofon Manualer
- Mikrofon Akg
- Mikrofon Neewer
- Mikrofon Pyle
- Mikrofon Shure
- Mikrofon Roland
- Mikrofon Auna
- Mikrofon Sennheiser
- Mikrofon Genesis
- Mikrofon Karma
- Mikrofon Xvive
- Mikrofon Comica
- Mikrofon Point Source Audio
- Mikrofon Samson
- Mikrofon Galaxy Audio
- Mikrofon Atlas
- Mikrofon Kopul
- Mikrofon Earthworks
- Mikrofon Anywhere Cart
- Mikrofon Movo
- Mikrofon Sescom
- Mikrofon Sonic Presence
- Mikrofon Sontronics
- Mikrofon Chandler
- Mikrofon Universal Audio
- Mikrofon United
- Mikrofon Tonsil
- Mikrofon Easyrig
- Mikrofon Royer Labs
- Mikrofon Polsen
- Mikrofon Warm Audio
- Mikrofon Rode
Nyeste Mikrofon Manualer
28 Oktober 2024
27 Oktober 2024
27 Oktober 2024
27 Oktober 2024
27 Oktober 2024
27 Oktober 2024
27 Oktober 2024
27 Oktober 2024
27 Oktober 2024
26 Oktober 2024