Dual MH200 Bruksanvisning

Les nedenfor 📖 manual på norsk for Dual MH200 (4 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 3 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/4
INSTALLATION/OWNER'S MANUAL
Universal MarineGimbal Housing
MH200
2
Protect your marine head unit from damage and the harsh marine environment with the
MH200 gimbal housing. This marine grade housing fits most single DIN size head units
and provides full protection against splashes and debris.
Before You Start
Disconnect negative battery terminal. Consult a qualified marine technician or service
manual for instructions.
Due to differences in head units, it is recommended to temporarily mount head unit in
the gimbal housing before installation to ensure the cover will close properly.
• Use extreme caution when drilling holes to avoid damaging fuel lines or existing wiring.
Mounting Bracket Dimensions
Opening and Closing the Gimbal Housing 
• Press the release button on top to open the cover and access the head unit.
• To close, fold the cover up and press until it clicks into place.
MH200 INSTALLATION
Preparation
Release Button
3
Mounting
• Prepare surface for mounting the gimbal housing bracket. For maximum installation
flexibility, the gimbal housing bracket can be mounted to any flat surface or it can also
be suspended.
• Use the bracket as a template and mark and drill the holes for the mounting bracket.
Use caution before you drill or cut! Be careful not to cut or drill into gas tanks, fuel lines,
hydraulic lines, vacuum lines or electrical wiring.
• Secure the mounting bracket using supplied hardware. Attach gimbal housing by
inserting the thumbscrews through the bracket and into the gimbal housing. Adjust the
desired angle and hand tighten the thumbscrews. Do not overtighten the thumbscrews.
• Route all head unit wiring to the gimbal housing. Using a suitable tool, carefully cut an
"X" in the desired rubber grommet. The grommets are interchangeable between the left
and right sides of the gimbal housing.
Install mounting sleeve (supplied with head unit) into gimbal housing. This may vary
depending on head unit manufacturer and installation instructions. Refer to head unit
owner’s manual for details.
Connect head unit wiring and test for correct operation.
MH200 INSTALLATION 
Mounting
TYPICAL MOUNTING
*Head Unit not included.

Produkspesifikasjoner

Merke: Dual
Kategori: Ikke kategorisert
Modell: MH200

Trenger du hjelp?

Hvis du trenger hjelp med Dual MH200 still et spørsmål nedenfor, og andre brukere vil svare deg




Ikke kategorisert Dual Manualer

Ikke kategorisert Manualer

Nyeste Ikke kategorisert Manualer