Joy-it ARD-RS232 Bruksanvisning

Les nedenfor 📖 manual på norsk for Joy-it ARD-RS232 (5 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 2 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/5
Joy IT powered by SIMAC Electronics GmbH Pascalstr. 8 47506 Neukirchen Vluyn www.joy it.net- - - - - -
RS232 SHIELD-
ARD RS232-
RS232 SHIELD-
ARD-RS232
1. GENERAL INFORMATION
Dear customer,
thank you very much for choosing our product.
In the following, we will introduce you to what to observe while starting
up and using this product.
Should you encounter any unexpected problems during use, please do
not hesitate to contact us.
2. PINOUT
The jumpers on the board can be used to set the pins with which the
board is used. By default these are set to RX > D0 and TX - -> D1.
All other pins can be used normally via the pin headers.
The pin assignment of the D Sub connector can be seen in the diagram -
below. The TX, RX and G pins must always be connected for use.
TX: transmit line; RX: receive line; G: reference potential

Produkspesifikasjoner

Merke: Joy-it
Kategori: Ikke kategorisert
Modell: ARD-RS232

Trenger du hjelp?

Hvis du trenger hjelp med Joy-it ARD-RS232 still et spørsmål nedenfor, og andre brukere vil svare deg




Ikke kategorisert Joy-it Manualer

Ikke kategorisert Manualer

Nyeste Ikke kategorisert Manualer