Milwaukee M18 2952-20 Bruksanvisning

Milwaukee Radio M18 2952-20

Les nedenfor 📖 manual på norsk for Milwaukee M18 2952-20 (16 sider) i kategorien Radio. Denne guiden var nyttig for 2 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/16
Cat. No. / No de Cat.
2952-20
M18 BLUETOOTH ® JOBSITE RADIO
RADIO DE CHANTIER BLUETOOTH ® M18™
RADIO PARA SITIO DE TRABAJO BLUETOOTH ® M18™
OPERATOR'S MANUAL
MANUEL de L'UTILISATEUR
MANUAL del OPERADOR
WARNING To reduce the risk of injury, user must read and understand operator's manual.
AVERTISSEMENT An de réduire le risque de blessures, l'utilisateur doit lire et bien
comprendre le manuel.
ADVERTENCIA Para reducir el riesgo de lesiones, el usuario debe leer y entender el manual.
WARNING To reduce the risk of injury, user must read and understand operator's manual.
AVERTISSEMENT An de réduire le risque de blessures, l'utilisateur doit lire et bien
comprendre le manuel.
ADVERTENCIA Para reducir el riesgo de lesiones, el usuario debe leer y entender el manual.
2
IMPORTANT SAFETY
INSTRUCTIONS
WARNING
READ, UNDERSTAND AND FOL-
LOW ALL INSTRUCTIONS. Failure
to heed all warnings listed below, may result in
electric shock, re and/or serious personal injury.
KEEP THESE INSTRUCTIONS.
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not install near any heat sources such as
radiators, heat registers, stoves, or other ap-
paratus (including ampliers that produce heat.)
Only use attachments/accessories specied by
the manufacturer.
Use only with the cart, stand, tripod, bracket, or
table specied by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to
avoid injury from tip-over.
Unplug this apparatus during lightning storms
or when unused for long periods of time.
Refer all servicing to qualied service personnel.
Servicing is required when the apparatus has
been damaged in any way,such as power-supply
cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the ap-
paratus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
WARNING
To reduce the risk of re or electric
shock, do not expose this appa-
ratus to rain or moisture.
Only plug power supply into readily accessible out-
let to allow the appliance to be unplugged quickly.
A battery operated radio with integral batteries or
a separate battery pack must be recharged only
with the specied charger for the battery. A char-
ger that may be suitable for one type of battery may
create a risk of re when used with another battery.
Use battery operated radio only with specically
designated battery packs. Use of any other bat-
teries may create a risk of re.
When battery pack is not in use, keep it away
from other metal objects like: paper clips, coins,
keys, nails, screws, or other small metal objects
that can make a connection from one terminal
to another. Shorting the battery terminals together
may cause sparks, burns, or a re.
Store your battery pack in a cool, dry place. Do not
store battery pack where temperatures may exceed
120°F (50°C) such as direct sunlight, a vehicle or
metal building during the summer.
Avoid body contact with grounded surfaces
such as pipes, radiators, ranges and refrigera-
tors. There is an increased risk of electric shock if
your body is grounded.
Only use the provided adaptor plug.
Never disassemble the radio or try to do any
rewiring on the radio's electrical system.
Do not expose this apparatus to dripping and
splashing, or place objects lled with liquids
on this unit.
SPECIFIC SAFETY RULES
Always use common sense and be cautious when
using tools. It is not possible to anticipate every
situation that could result in a dangerous outcome.
Do not use this tool if you do not understand these
operating instructions or you feel the work is beyond
your capability; contact Milwaukee Tool or a trained
professional for additional information or training.
Maintain labels and nameplates. These carry
important information. If unreadable or missing,
contact a MILWAUKEE service facility for a free
replacement.
Federal Communications Commission
Pursuant to part 15.21 of the FCC Rules, you
are cautioned that changes or modications
not expressly approved by the party responsible for
compliance could void your authority to operate the
product.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment o󰀨 and on, the user is encouraged to try
to correct the interference by one or more of the fol-
lowing measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
di󰀨erent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules
and ISED-Canada’s license exempt RSS standards.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference,
and 2) This device must accept any interference
received, including interference that may cause
undesired operation.
To maintain compliance with FCC’s RF Exposure
guidelines, This equipment should be installed and
operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.
3
EXTENSION CORDS
Grounded tools require a three wire extension
cord. Double insulated tools can use either a two
or three wire extension cord. As the distance from
the supply outlet increases, you must use a heavier
gauge extension cord. Using extension cords with
inadequately sized wire causes a serious drop in
voltage, resulting in loss of power and possible tool
damage. Refer to the table shown to determine the
required minimum wire size.
The smaller the gauge number of the wire, the greater
the capacity of the cord. For example, a 14 gauge
cord can carry a higher current than a 16 gauge cord.
When using more than one extension cord to make
up the total length, be sure each cord contains at
least the minimum wire size required. If you are using
one extension cord for more than one tool, add the
nameplate amperes and use the sum to determine
the required minimum wire size.
Guidelines for Using Extension Cords
If you are using an extension cord outdoors, be sure
it is marked with the su󰀩x “W-A” (“W” in Canada)
to indicate that it is acceptable for outdoor use.
Be sure your extension cord is properly wired
and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a
qualied person before using it.
Protect your extension cords from sharp objects,
excessive heat and damp or wet areas.
Recommended Minimum Wire Gauge
For Extension Cords*
Nameplate Amps
Extension Cord Length
25' 50' 75' 100' 150'
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 16.0
16.1 - 20.0
18
18
18
18
16
14
12
18
18
18
16
14
12
10
18
18
16
14
12
10
--
18
16
14
12
10
--
--
16
14
12
12
--
--
--
* Based on limiting the line voltage drop to ve volts at 150%
of the rated amperes.
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICABLE PARTS INSIDE. REFER SERVICI-
ING TO QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
- The lightning ash with arrowhead symbol, within an equi
lateral triangle, is intended to alert the user to the presence
of uninsulated "dangerous voltage" within the product's
enclosure that may be of su󰀩cient magnitude to constitute
a risk of electric shock to persons.
- The exclamation point within an equilateral triangle is in
tended to alert the user to the presence of important operat-
ing and maintenance (servicing) instructions in the literature
accompanying the appliance.
READ AND SAVE ALL INSTRUCTIONS
FOR FUTURE USE.
FUNCTIONAL DESCRIPTION
1. Power button
2. Bluetooth® button
3. AM/FM button
4. Preset button
5. Clock button
6. EQ button
7. Display
8. Play/Pause button
9. Seek/adjust buttons
10. Volume buttons
11. Antenna
12. Battery bay
13. Backup-battery compartment
14. Power adapter port
15. Port cover
16. USB-C power outlet
16
14
15
11
13 12
1 1098765432
SPECIFICATIONS
Cat. No. 2952-20 .....................................................
Battery Type .................................................M18™
Charger Type M18™................................................
AC Input Volts ................................................ 120 V
AC Input Amps.................................................1.2 A
DC Input Volts ................................................. 18 V
DC Output Volts ............................................... 18 V
DC Output Amps.................................................3 A
Output Volts USB-C ........................................... 5 V
Output Amps USB-C...........................................3 A
FCC ID .............................................2AB9S-2952-20
Replacement adapter .............................42-04-0021
Recommended Ambient
Operating Temperature ....................14°F to 104°F
(-10°C to 40°C
)

Produkspesifikasjoner

Merke: Milwaukee
Kategori: Radio
Modell: M18 2952-20

Trenger du hjelp?

Hvis du trenger hjelp med Milwaukee M18 2952-20 still et spørsmål nedenfor, og andre brukere vil svare deg