Imarflex IWD-1140W Bruksanvisning

Les nedenfor 📖 manual på norsk for Imarflex IWD-1140W (3 sider) i kategorien Vanndispenser. Denne guiden var nyttig for 2 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/3
SPECIFICATION:
MODEL NO. : IWD- 1140W
POWER CONSUMPTION : Hot 420W
Cold W 85
RATED VOLTAGE : 230Va.c. 60Hz
BOX DIMENSION : 326*340*965mm
IMPORTANT SAFEGUARDS:
When using electrical appliances, basic safety precautions should always be followed, including the following:
1. Read all instructions thoroughly.
2. Before using the Water Dispenser, check if the voltage indicated corresponds with the convenience outlet (230Va.c.).
3. Do not use two-way socket with another appliance.
4. Do not use any appliance with a damaged cord or plug. If the cord is damaged, it must be replaced with the same type and
size of a qualied person or bring the unit to the manufacturer or to the nearest Imarex Authorized Service Center to avoid
hazard.
5. To avoid a hazard due to instability of the appliance, it must be xed in accordance with the instructions.
6. Do not place the Water Dispenser near gas stove, electric burner or heated oven.
7. Children should be supervised to ensure that they do not play with the appliance.
8. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the
appliances by a person responsible for their safety.
9. Keep the water dispenser in a dry and cool place and avoid direct sunlight. Rearward of the machine should be at least
20cm far from the wall. Never put the machine on the paper or foam, which may cause unstable condition, such as store
water or cause creepage. Never put anything ammable beside this machine.
10. To avoid damage, do not plug the power cord or turn on the heating switch until 3 minutes after you put the lled water
gallon.
11. This water dispenser must be used with third-prong grounding plug and creepage protection switch. If two at plugs will
use, the grounding wire must be properly grounded before use.
12. In case the unit will not use for a long time, turn o the switch and pull the plug out from the socket then drain the remaining
water through drain hole.
13. Never use organic liquid to clean the machine. Splashing of water to the body is strictly prohibited.
14. You should use the ON/OFF switch to turn on or o the unit. It is prohibited to turn on or o the unit through plugging or
unplugging the power cord. Never extend the length of the power supply cord to avoid re.
15. Never turn the machine upside down or lean it more than 45°.
16. Do not adjust the thermostat of the unit by yourself.
17. Power cord or other parts of the unit must be replaced by authorized service center personnel.
18. The cooling time of the unit might take longer when the environment temperature is higher than the normal.
19. Save this instruction for future reference.
DESCRIPTION OF PARTS:
NUMBER
PART NAME
1
Gallon Supporter
2
Cold Water Button
3
Room Temp Water Button
4
Hot Water Button
5
Cooling Light Indicator
6
Room Temp Water Light Indicator
7
Boiling Water Light Indicator
8
Water Spout
9
Water Collector
10
Built-in Cabinet
11
Hot Power Switch
12
Cold Power Cord
13
Condenser
14
Power Cord
15
Drain Valve
HOW TO USE:
1. Tear the label from the water gallon.
2. Turn the water gallon upside down then vertically insert the water gallon into the gallon supporter on top of the machine.
3. Insert the plug to the socket; turn on the power switch located at the back portion of the unit. The indicator lights up
accordingly once the machine works.
4. Vertically pull out the water gallon by two hands when the gallon is empty and replace it with another gallon of water.
CLEANING AND MAINTENANCE:
Prepare bleach disinfecting solution
Mix 1 teaspoon (5ml) of household bleach with 1 liter of water. make this any stronger. If you make extra solution, Do not
this should be used up within 30 days. Safety note: Use vinegar instead if you are sensitive to bleach
: Open the taps and take o the cap and rubber stopper from the water outlet on the rear side of the Draining Instruction
unit
Clean your water dispenser
1. Unplug the unit.
2. Remove the empty water gallon.
3. Remove no-spill top and/or bae if equipped.
4. Wearing gloves and safety goggles, scrub interior of reservoir and nozzle(s) with sponge soaked in bleach
solution. Let the solution stand for more than 2 minutes but less than 5 minutes to avoid plastic corrosion.
5. Fill the reservoir with clean tap or bottled water to rinse four (4) times and drain into a bucket. Dispose into sink.
6. Clean the drip pan, no-spill top and bae with bleach solution as well. Rinse and replace.
Replace and use new gallon to ll dispenser. If there is any remaining smell, continue rinse process
TROUBLE SHOOTING:
PROBLEM
POSSIBLE CAUSE
REMEDY
No hot or cold water
Over Consumption of hot
or cold water in short time
No power supply
The hot and cold water
will be available after a
while
Connect the plug and
turn on heating or
cooling switch
No running water from the
taps
Empty gallon
Inlet of gallon supporter
blocked by gallon seal
Replace it with a new
water gallon
Clean wasted paper and
gallon seal and re-install
the water gallon
Leakage from gallon
supporter
Broken water gallon
Replace it with a new
water gallon
Noise Operation
No placid installation
Place the unit on placid
& solid surface
REMINDER: Please do not forget to ll up and send the warranty card with receipt to our email address
imarexfb@evergoodinc.com
Distributed By: Topgadget Distributions, Inc.
2120 A. Linao St. Malate, Manila
Made in China

Produkspesifikasjoner

Merke: Imarflex
Kategori: Vanndispenser
Modell: IWD-1140W

Trenger du hjelp?

Hvis du trenger hjelp med Imarflex IWD-1140W still et spørsmål nedenfor, og andre brukere vil svare deg