Joy-it SBC-OLED01.3 Bruksanvisning

Joy-it Følge SBC-OLED01.3

Les nedenfor 📖 manual på norsk for Joy-it SBC-OLED01.3 (10 sider) i kategorien Følge. Denne guiden var nyttig for 4 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/10
1.3" OLED DISPLAY
OLED display with SPI & I2C interface
Joy-IT powered by SIMAC Electronics GmbH - Pascalstr. 8 - 47506 Neukirchen-Vluyn - www.joy-it.net
Dear customer,
thank you for choosing our product. In the following, we will show
you what you should pay attention to during commissioning and use.
Should you encounter any unexpected problems during use, please feel
free to contact us.
The graphical 1.3" OLED display has a resolution of 128x64 pixels
and communicates via the SPI interface. Optionally, the display can
also be soldered to the I2C interface on the back.
The interface of the module can be selected by re-soldering the marked
resistors:
1. GENERAL INFORMATION
2. BASICS & INTERFACES
ATTENTION. The display uses a logic level of 3.3 V. For this reason, a voltage
converter must be used for use with a device that has a logic level voltage of
5 V (e.g. Arduino Uno). In our example we use the COM-KY051VT.
USE VIA THE SPI PROTOCOL:
First, connect the module to your Arduino as follows:
3. APPLICATION EXAMPLE ARDUINO

Produkspesifikasjoner

Merke: Joy-it
Kategori: Følge
Modell: SBC-OLED01.3

Trenger du hjelp?

Hvis du trenger hjelp med Joy-it SBC-OLED01.3 still et spørsmål nedenfor, og andre brukere vil svare deg




Følge Joy-it Manualer

Følge Manualer

Nyeste Følge Manualer